Disconnecting The Radio Link; Operation; Normal Operation - KIPP K1494.01 Bedienungsanleitung

5. Com m is sio n i n g , O p er a ti o n
5.3.2 Di s con n e c ti ng t he r a di o l i nk
To disconnect a KIPP device, e.g. an indexing plunger with status sensor, from the input channels 1 to 6,
proceed as follows:
1. Press the pairing button of the input channel being disconnected for 10 seconds.
 As soon as the link is disconnected, the three LED's of the selected input channel flash 4 times in
succession. The „Radio Link" LED then goes out.
Disconnecting a mobile terminal from the UI input channel:
1. Press the button of the UI input channel for 10 seconds.
 As soon as the link is disconnected, the "Radio Link" LED goes out.
 Alternatively, the disconnection can be done via the mobile device.
5.4 Ope rat i on
5.4.1 N orm al o p e r at i o n
After successful commissioning, the connected KIPP devices, e.g. indexing plungers with status sensor,
send the actuation status and the battery charge level to the Gateway at a transmission rate of 10 1/s.
An existing radio link, the actuation status and a required battery change can be identified for the
respective channel by means of the LED's on the control panel.
If the actuation status of the indexing plunger changes, the information is sent to the relay output and
the switching status of the changeover contact changes in accordance with the wiring.
INFO!
Secure radio communication / Connected devices
The communication between the indexing plunger and the Gateway receiver is encrypted.
Due to the unique identification, connected devices remain connected until they are manually
disconnected by the operating personnel in accordance with chapter 5.3.2.
HEINRICH KIPP WERK GmbH & Co. KG
Heubergstrasse 2
72172 Sulz am Neckar
Tel. +49 7454 793-0
Fax +49 7454 793-33
41
info@kipp.com
www.kipp.com Status: 26.11.2020