Control Panel - Klarstein METROBREEZE ROM SMART Handbuch

EN

CONTROL PANEL

Press this button to turn on or off the air conditioner, and the
POWER
powered indicator lamp is normally on.
During on or timer on pressing this button can select COOL,
MODE
DEHUMIDIFY, FAN etc. The corresponding indicator lamp to
the selected mode is on.
If the timer on or timer off is set, pressing UP or DOWN can
adjust on/off time; in running state of COOL or timer state,
UP/DOWN
pressing UP or DOWN can adjust the set temperature;
and pressing UP and DOWN simultaneously can realize
conversion between and , and is displayed in default.
Pressing this button can select different speeds in cycle of
HIGH, MID and LOW; in FAN mode press this button for 5s
SPEED to run the internal dry function, press this button for another
5s to cancel, the corresponding indicator lamp to the
selected speed is on.
Press this button to enter timer setting state, and the indicator
TIMER
lamp is on.
This pattern displays the set temperature in COOL and
HEAT modes, and displays room temperature in FAN
88 and DEHUMIDIFY modes; display of °C shows current
centigrade temperature, and display of °F shows current
Fahrenheit temperature.
This indicator lamp is normally on when SLEEP state is
SLEEP
started.
In water full state this indicator lamp flickers with buzzer to
WATER FULL
prompt drainage.
Press and hold the fan and timer buttons simultaneously for 2
TIMER + SPEED
seconds to activate the swing function of the slats.
30