23
Guidance and manufacturer's declaration – Electromagnetic Emissions
The CLINIC PLUS SUCTION ASPIRATOR is intended for use in the electromagnetic environment specified below. The
customers or the user of the CLINIC PLUS SUCTION ASPIRATOR should assure that it's used in such an environment.
Emissions Test
Irradiated / Conducted
emissions CISPR11
Irradiated / Conducted
emissions CISPR11
Harmonic emissions
EN 61000-3-2
Voltage fluctuations /
flicker emissions EN 61000-3-3
Guidance and manufacturer's declaration – Immunity Emissions
The CLINIC PLUS SUCTION ASPIRATOR is intended for use in the electromagnetic environment specified below. The
customers or the user of the CLINIC PLUS SUCTION ASPIRATOR should assure that it's used in such an envitonment.
Immunity Test
Electrostatic
discharge
(ESD) EN 61000-4-2
Electrical fast
transient / burst
EN 61000-4-4
Surge
EN 61000-4-5
Volgate dips, short
interruptions and
voltage variations on
power supply input
lines EN 61000-4-11
Magnetic field
(50/60 Hz)
EN 61000-4-8
Note UT is the value of the power supply voltage.
Compliance
Group 1
Class [B]
Class [A]
Complies
level indicated by the
En 60601-1-2
+/-8kV contact
+/-15kV in air
+/-2kV power supply
lines
+/-1kV for input / output
lines
± 0,5kV
± 1,0kV differential mode
<5% U
(>95% dip U
)
T
T
for 0,5 cycle
40 % U
(60% dip U
)
T
T
for 5 cycle
70 % U
(30% dip UT )
T
for 25 cycle
<5 % U
(>95% dip U
)
T
T
for 5 sec
30A/m
Electromagnetic environment - guidance
The CLINIC PLUS SUCTION ASPIRATOR only used RF energy
only for its internal functioning. Therefore its RF emissions are very
low and are not likely to cause any interference in nearby electronic
equipment.
The appliance is suitable fopr use in alla establishments included
domestic establishments and those directly connected to the public
low-voltage power supply network that supplies buildings used for
domestic purposes.
Compliance level
The
device
doesn't
change its state
The
device
doesn't
change its state
The
device
doesn't
change its state
- -
The
device
doesn't
change its state
english
Electromagnetic environments - guid-
ance
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Mains power quality should be that of
a typical commercial or hospital enviro
ment.
Mains power quality should be that of a
typical commercial or hospital environ-
ment.
Mains power quality should be that of a
typical commercial or hospital environ-
ment. If the user of the CLINIC PLUS
SUCTION ASPIRATOR requires contin-
ued operation during power mains inter-
ruptions, it is recommended that the de-
vice be powered from an uninterruptible
power supply or a battery.
The power frequency magnetic field
should be measured in the intended in-
stallation location to assure that it's suf-
ficiently low.