Electrical Connection - Daikin AHT MONTREAL XL Betriebsanleitung

8 | Setup and installation
Minimum spacing for block setup
A= 0 mm (0 in)
B= 125 mm (4.9 in)
Fig. 8: Minimum spacing for block setup
Reason for removal and installation of the lids:
– Carrying out a complete defrosting with subse-
quent cleaning.
– Damage from lid.
Safety when handling glass [see } Chapter 2.5.3].
Unit with push-back glass lid
1
5
Fig. 9: Push-back glass lid
Upper edge of de-
1
vice frame
3 Guide
5 Sealing lip
Removing lid
a) Use the handle to slide cover A all the way back
except for a finger's width.
b) Hold cover A at the handle and at the center in the
back.
c) Slightly lift cover A at the rear over the upper edge
of the device frame, slide it back and lift it out.
d) Slightly light cover B and lift it out to the front.
Installing lid
e) Insert cover B at the rear. Cover B must be under
the cover lock. The sealing lip of cover B is at the
front top.
42 / 104
2
3
4
2 Cover lock
4 Device front
A, B Lid A, Lid B
AHT Cooling Systems GmbH | en-US
Fig. 10: Cover lock (1), lid B (2)
f) Hold cover A at the handle and at the center in the
back.
g) Place cover A at the upper edge of the device
frame at the rear and over cover B at the front.
h) Use the handle to pull cover A along the guide to
the front and close it.
1
Fig. 11: Guide (1), lid A (2)
i) Check for correct functioning.
Unit with glass sliding lid
Fig. 12: Glass sliding lid
Removing lid
j) Open the lid.
k) With both hands, lift the lid at the rear and pull
back until it can be removed to the front.
l) Carefully lift out lid with both hands.
Installing lid
m)Insert the lower smaller lid.
n) Insert the upper lid.
o) Close the lids completely.
p) Check for correct functioning.
8.1

Electrical connection

The connection to the power supply is made by the
operating company.
Technical data [see } Chapter 3.2]
Start-up [see } Chapter 9]
1
2
2
440195_1_0521