Napoleon PRO 500 Handbuch Seite 92

Problem
Ignitor, oven and cabinet
lights work but the knob
lights don't illuminate when
turning the power switch
ON
Illumination of the knob
and switch lights work fine,
but the side/rear burner
ignition does not work
Illumination but can't ignite
the side or rear burner,
even when sparking noise
occurs
The knob and switch lights
blink eight times with 0.5
seconds intervals and then
turn off.
N415-0539CE-GB-DE Jul 14.20
Possible Causes
The motion sensor detector does not
work properly
The wire harness does not work properly
The ignitor switch does not work properly
The ignitor block does not work properly
The gap between electrodes is too big or
too small
The batteries are low
Solution
Ensure the blue indicator is ON
Turn the sensor ON by clicking the motion
detector button
If blue indicator is ON, replace the motion
sensor
Replace the wire harness of the control panel
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside the control
panel If there's no light on the switch when you
turn it on.
Replace the ignitor block if the switch
illuminates and sparking noise can be heard.
Adjust the gap between two prongs of the side
burner electrode when the side burner does not
ignite.
Adjust the gap between the electrode and the
rear burner when the rear burner when the rear
burner foes not ignite
Replace the batteries
19
EN
www.napoleon.com