Napoleon PRESTIGE 500 Handbuch Seite 90

Problem
Infrared burner (if Ceramic tiles overloaded with grease
equipped) flashes back drippings and build-up. Ports are clogged.
(during operation the
burner abruptly makes
a loud "whoosh" sound, Burner overheated due to inadequate
followed by a continuous ventilation (too much grill surface covered
blow-torch type sound by griddle or pan.)
and grows dim.)
Cracked ceramic tile.
Leaking gasket surrounding the ceramic
tile, or a weld failure in the burner
housing.
Pilot will not light. Lack of gas.
(if equipped)
Obstruction in pilot orifice.
Electrode wire loose or off.
Dirty pilot electrode.
Pilot is actually lit.
Ignitor works but the knob The knob lights wire connector
blue lights don't illuminate disconnected from the main wire
when turn on the light connector
switch and the knob red The light switch doesn't work properly
lights also don't illuminate
when turn on the gas The wire harness doesn't work properly
burners
The batteries are low
Illuminations of the knob The ignitor switch doesn't work properly
and switch work fine but
side/rear burner ignition
does not work
The ignitor block doesn't work properly
Illumination and Side/Rear The gap between electrodes is too big or
burner Ignition work fine too small
but I can't ignite the side
or rear burner even when
sparking noise occurs
The knob and switch lights The batteries are low
blink eight times with 0.5
seconds intervals and then
turn off.
N415-0518CE-GB-DE AUG 05.20
Possible Causes Solution
Turn burner off and allow to cool for at least two
minutes. Relight burner and burn on high for at
least five minutes or until the ceramic tiles are
evenly glowing red.
Ensure that no more than 75% of the grill
surface is covered by objects or accessories.
Turn burner off and allow to cool for at least two
minutes, then relight.
Allow burner to cool and inspect very closely
for cracks. If any cracks are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
After turning pilot knob to high, wait
approximately 20-30 seconds for air to purge
the gas supply line while pressing igniter. Fill
propane cylinder. During initial set-up or after
tank has been refilled, it is best to light one
of the tube burners before lighting the pilot
burner. This enables the gas to reach the valves
on the manifold more quickly.
Clean pilot orifice.
Replace lead wire.
Clean pilot electrode.
The pilot flame, especially on natural gas units
is very difficult to see. Place your hand 1 in. (2.5
cm) above grill surface over the pilot burner to
feel for heat.
Connect the knob light wire connector to the
main wire connector inside of the control panel
Replace the light switch
Replace the wire harness of the control panel
Replace the batteries
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside the control
panel if there's no illumination on the switch
when you turn it on
Replace the ignitor block if the ignitor switch
illuminates and sparking noise can't be heard
Adjust the gap between two prongs of the side
burner electrode when the side burner doesn't
ignite
Adjust the gap between the electrode and the
rear burner when the rear burner doesn't ignite
Replace the batteries
17
EN
www.napoleon.com