Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance, cleaning and repair
u Maintenance: Regularly check that the screw connection is tight.
u Cleaning: Use a slightly damp cloth to clean the camera stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Repair any damage immediately and stop using the camera stand. Repair work may
u
only be carried out if you have the necessary knowledge. If any parts are missing, contact the
u
manufacturer at www.k-m.de. Here you can find a corresponding spare parts list by entering
u
the article number on the type label. Use this page to reorder missing or damaged compo
u
nents.
Fault and troubleshooting
Fault/cause
Stand wobbles
Equipment wobbles
on ball joint
Storage, disposal
Store the camera stand in a dry place.
Recycle disassembled components:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them
u
according to local regulations.
Contact information
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2
97877 Wertheim
Germany
Telefon: 09342/8060
Telefax: 09342/806-150
E-Mail: contact@k-m.de
Web: www.k-m.de
19784-100-55 Rev.02 03-80-044-00 5/21
Check/Remedy
● Check the surface for unevenness.
● Increase foot circle diameter.
● Check screw connections for tightness and tighten if
●
necessary.
Werbung
