Maintenance, Cleaning And Repair - Konig & Meyer 19781 Nutzungsinformation

3.) Mounting the equipment and adjusting the desired position
!When adjusting the position, there is a crushing risk between the components!

Maintenance, cleaning and repair

u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the desktop camera stand.
u
Do not use chlorinated or abrasive cleaning agents. These will cause damage to the surface
u
and varnish.
u Repair: Immediately repair any damage that occurs and stop using the desktop camera stand.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing, contact the manufacturer at www.k-m.de. Here you can find a corresponding
u
spare parts list by entering the article number on the type label. Use this page to reorder
u
missing or damaged components.
Fault and troubleshooting
Fault/cause
Stand wobbles
Equipment wobbles on
universal joint
Screw the equipment onto the stand. If necessary, the
equipment can be locked in place with the help of the
knurled disc.
To adjust the direction or the angular position, hold the
screwed-on equipment and loosen the clamping screw.
Set the desired position and retighten the clamping
screw.
Dismantling is carried out in reverse order.
Check/Remedy
● Check the surface for dirt or unevenness.
● Check screw connections for tightness and tighten if
● necessary.