Technical Data; Maintenance, Cleaning And Repair - Konig & Meyer Easy Lock 21439 Nutzungsinformation

Technical data

Material
Load capacity
Dimensions and
adjustment range
Packing
Weight

Maintenance, cleaning and repair

u Maintenance: Regularly check that the screw connection is tight.
u Cleaning: Use a slightly damp cloth to clean the speaker stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Repair any damage immediately and stop using the speaker stand. Repair work may
u
only be carried out if you have the necessary knowledge. If any parts are missing, contact the
u
manufacturer at www.k-m.de. Here you can find a corresponding spare parts list by entering
u
the article number on the type label. Use this page to reorder missing or damaged compo-
u
nents.
Fault and troubleshooting
Fault/cause
Stand wobbles
Extension tube slides in
under a load
Speaker cannot be placed
on expanding mandrel
Speaker is not adequately
fixed in place
Speaker is difficult to remove
from expanding mandrel
Foot, base, extension tube, foot strut, safety hook:
steel, powder-coated, black
Rivets, screws: steel, galvanized
Distance bolt, springs: steel, uncoated
Clamping screws, bushings, clamping element, clamping sleeve, clip,
foot end caps: plastic, black
50 kg
Max root circle diameter: 1150 mm
Height: 1417–2117 mm, 5 x 140 mm
Expanding mandrel: diameter 35-37 mm
(W) 1185 x (D) 130 x (H) 120 mm
6.0 kg
Check/Remedy
● Check the surface for unevenness.
● Set the maximum root circle diameter.
● Secure the safety hook in place.
● Tighten the clamping screws.
● Check flange bushing diameter.
● Check whether the clamping sleeve is in the open position.
● Check flange bushing diameter.
● Check whether the clamping sleeve is in the open position.