Maintenance, Cleaning And Repair - Konig & Meyer 24624 Nutzungsinformation

5.) Align the rod combination

Maintenance, cleaning and repair

u Maintenance: Regularly check that the screw connection is tight.
u Cleaning: Use a slightly damp cloth to clean the lighting stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Repair any damage immediately and stop using the lighting stand. Repair work may
u
only be carried out if you have the necessary knowledge. If any parts are missing, contact the
u
manufacturer at www.k-m.de. Here you can find a corresponding spare parts list by entering
u
the article number on the type label. Use this page to reorder missing or damaged compo-
u
nents.
Fault and troubleshooting
Fault/cause
Sound system wobbles
Extension tube slides in
under a load
After assembly 2.), the clamping screw or safety
hook may point in an undesired direction. This
can be corrected as follows. Loosen the SW40
lock nut on the underside of the base plate 1;
suitable wrench: K&M 26702. Align the rod com-
bination in the desired position 2 and re-tighten
the lock nut 3.
Check/Remedy
● Check the stability of the sound system.
● Check screw connection between the base and rod combi-
● nation and the SW40 lock nut and tighten if necessary.
● Secure the safety hook in place.
● Tighten the clamping screws.