Maintenance, Cleaning And Repair - Konig & Meyer AC 6001 SP Nutzungsinformation

Maintenance, cleaning and repair

u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the speaker stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Immediately repair any damage that occurs and stop using the speaker stand.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing,contact the manufacturer at www.k-m.de.
Fault and troubleshooting
Fault/cause
Base cannot be connected to the
base tube
Base cannot be fully inserted into
the base tube
Stand wobbles or does not stand
up securely
Speaker does not attach securely
or cannot be clamped
Storage, disposal
Store the speaker stand in a dry place.
Recycle the components after they are disassembled:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them
u
according to local regulations.
Check/Remedy
● Check to ensure that the parts are assembled correctly,
● with particular attention to the lengths of the crosspieces
● at the base tube.
● Check to ensure that the parts are assembled correctly,
● with particular attention to the lengths of the crosspieces
● at the connecting plate.
● Check the surface and area where it is set up.
● Check the screw connection between the base and
● base tube and tighten if necessary.
● Be sure to use the right opening for your speaker.
● The clamping bolt must be fully inserted into the keyhole
● opening.
● Tighten the clamping nut.