Maintenance, Cleaning And Repair - Konig & Meyer 29605 K&M AC 6002 SP Nutzungsinformation

4.) Attach the speaker to the stand

Maintenance, cleaning and repair

u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the speaker stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Immediately repair any damage that occurs and stop using the speaker stand.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing,contact the manufacturer at www.k-m.de.
Attach the speaker as shown. Guide the
speaker cable through the attachment strip
and attach it to the speaker. To do this, note
the operating instructions for the speaker set
used.
1 Insert the clamping bolt into the keyhole
opening and push it in the direction of the
arrow 2. Make sure the bolt is fully inserted
into the slot. Set the attachment strip over
the clamping bolt and screw it into place with
the washer and nut. Place the protective cap
over the top nut
 The stand is securely set up.
 The attachment strip is firmly screwed onto the speaker.
 The speaker cable is connected and runs downward

through the attachment strip.
Use the attachment strip to attach the speaker to the stand
using the drill holes provided. Make sure the speaker cable
is not pinched in the process. Screw into place with washer
and nut from the back side. Press the protective cap onto
the nut.