Operating Instructions; Power Supply - SISER TS-BASE Gebrauchsanweisung

TS
BASE

3 OPERATING INSTRUCTIONS

3
This manual was structured to guarantee it is easy to understand.
Read the manual carefully and follow the guide step by step to obtain the best result.
EN
• Work carefully and avoid contact with the heating plate to prevent serious injuries.
• During closure, never place hands near the heating plate, to avoid crushing and burns.
• Only position the press on stable, non-slip and non-moving surfaces. The machine can also be
fastened to the surface using screws: the pedestal has the specific holes.
• Once the packaging is opened, immediately check for any damage present during transport.
Leave the press at ambient temperature for a few hours before first use to prevent
condensate formation and possible resulting short circuit.
• Use the press standing and holding the specific handle with both hands. In relation to this, the
height of the machine must be adjusted based on the operator's height.
• Optimal working conditions for the press include maximum humidity equal to 70% and an
ambient temperature between +15°C and +50°C.
• If a solid object or liquid penetrates the equipment, immediately and carefully remove the
plug from the socket and have a specialist technician check the machine before new use.
• Damage cannot be excluded to property and people in the event of improper use of the
machine or non-compliance with intended use, with the manufacturer relieved of all liability.

3.1 Power supply

Before connecting the pressure to the electricity mains, check the working voltage corresponds
to the mains voltage of 230V.
The socket must have fuse protection with at least 16 Amperes.
Connect a single machine to each socket.
Do not use extensions, since this could cause the cable to overheat (danger of fire)
or dips in voltage.
24
TS-BASE Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
NOTE: if the power cable is
damaged, it must be replaced
by the manufacturer or by a
qualified technician to prevent
electrocution.
For replacement, use a cable mod.
HSJ with 250 V-10 A.