Time; Time Setting - SISER TS-BASE Gebrauchsanweisung

5 TIME

5.1 Time setting

• Press the "Mode" button twice on the side of the LED display. The lights (SET) and (TIME)
placed beside the display light up to indicate passage to the time setting mode.
• Using the plus button "+" and minus button "-", you can increase or decrease the time until
the desired seconds are shown on the display. The time can be set from 001 to 999 seconds.
Once the desired time is set, press the "Mode" key again to confirm; at this stage, the lights on
the left on the display will switch off. Now you can start the transfer process.
"Decrease" button (-)
ATTENTION:
If one of the lights beside the display is on, the user is still in setting mode.
The press cannot be used to print when found in this mode!
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Digital display
SET
TIME
"Increase" button (+)
"Mode" button
TS-BASE Manual for use and maintenance
Mod. PRD 20/3 - Last updating 10/2019
Temperature indicator
SET indicator
TIME indicator
TS
BASE
5
EN
27