Terms Of Guarantee; Warranty Policy; Liability; Ce - Certification - Reference Standards - SISER TS-BASE Gebrauchsanweisung

9 TERMS OF GUARANTEE

9.1 Warranty policy

SISER S.r.l. guarantees its TS-BASE machine for a period of 24 months from the
date of shipment.
The warranty will only be recognised if the machine was used correctly following the
instructions given in this manual, including the periodic maintenance planned.
During the warranty period, any defective or broken parts will be repaired or replaced free of
charge by SISER S.r.l. on its premises in Vicenza.
Any defective parts replaced must be returned to Siser S.r.l. after replacement.
The purchaser assumes all transport or delivery charges of the spare parts
All consumables and materials used for routine maintenance are excluded from the warranty,
as well as any parts damaged due to improper use of the machine.
Repairs and/or replacements made during the warranty period do not extend the warranty.
Recognition of this warranty does not include reimbursement of any damages for lost
production.

9.2 Liability

The guarantee of proper function and performance of this machine and its intended use
depends on the strict enforcement of all the instructions documented within this manual.
The only configurations and uses allowed by the manufacturer are those
expressly described in the manual.
SISER S.r.l. assumes no liability for:
• failure to comply with the instructions relative to installation, use and maintenance as
described in this manual;
• system and environmental conditions that are not conducive for the machine to perform;
• unauthorized alterations to the machine;
• operation by unqualified and untrained personnel.

9.3 CE - CERTIFICATION - Reference standards

The TS-BASE machine is equipped with electrical parts operating at a voltage ranging between
50 V and 1000 V alternating current, and is subject to the Low Voltage Directive 2014/35/EU
and the Electromagnetic Compatibility Directive 2014/30/EU.
Users must remember that in addition to following the instructions in this manual,
the legislation on the subject of safety within your country must also be adhered to.
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
TS-BASE Manual for use and maintenance
Mod. PRD 20/3 - Last updating 10/2019
TS
BASE
9
EN
31