Pressure; Pressure Setting - SISER TS-BASE Gebrauchsanweisung

TS
BASE

6 PRESSURE

6

6.1 Pressure setting

The pressure adjustment knob is positioned at the centre of the heating plate.
EN
Adjust the pressure by rotating the knob clockwise to increase pressure and anti-clockwise to
decrease it.
If the pressure set does not provide the expected results, simply change it by rotating the
adjustment knob again clockwise or anti-clockwise whether you want to increase or decrease
the pressure.
NOTE:
Remember to always adjust pressure based on the type of fabric used since its thickness can
influence the pressure.
WARNING:
Do not force close the press in the event of excess pressure to avoid damaging the machine.
This damage is not covered by warranty.
28
Pressure adjustment knob
TS-BASE Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019