Temperature; Setting The Temperature - SISER TS-BASE Gebrauchsanweisung

TS
BASE

4 TEMPERATURE

4

4.1 Setting the temperature

• Press the "Mode" button on the LED display. The lights (SET) and (TEMP) placed beside the
EN
display light up to indicate passage to the temperature setting mode.
• Using the plus button "+" and minus button "-", you can increase or decrease the
temperature until the desired degrees are shown on the display.
• The temperature can be adjusted from 96°C to 221°C.
Once the desired temperature is set, press the "Mode" key again to confirm; at this stage, the
lights on the left on the display will switch off. The current temperature is indicated on the
digital display. When the press reaches the desired temperature, the transfer process can
start.
ATTENTION:
If one of the lights beside the display is on, the user is still in setting mode.
The press won't heat when in this mode!
26
Digital display
"Increase" button (+)
"Mode" button
"Decrease" button (-)
TS-BASE Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
SET
TIME
Temperature indicator
SET indicator
TIME indicator