Faults Table - Atag HG6192P Handbuch

MAINTENANCE
Brass wok burner parts
A few parts of the work burner are made from brass. It is normal
for the colour of the brass to change as a result of the high
temperatures that occur when cooking with a wok.
Keradur® burner bases
The burner bases have a unique Keradur® surface coating. The
special dirt-repelling lacquer has a ceramic filling which makes
cleaning easier and substantially improves the durability of the
burners. The burner bases are best cleaned with a mild cleaning
product and a soft cloth.
ATAG Shine
Atag Nederland supplies a range of cleaning agents under the
name ATAG Shine. These can be obtained at the website at
www.hps.nl, where you will also find various cleaning and
operating tips.
GB 12
General FAULTS

Faults table

FAULTS
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below in the table or visit our website
www.hps.nl for more information.
CAUSE SOLUTION
A burner is turned on but Close the tap and wait
not lit. for a few minutes before
relighting.
The coupling on a bottled Tighten the coupling.
gas unit has come undone.
Plug not in socket. Push the plug into the socket.
Fuse defective/fuse in meter Fit a new fuse or switch the
cabinet switched off. automatic fuse back on.
Sparkplug dirty/damp. Clean and dry the sparkplug.
Burner parts not correctly Assemble the burner parts
installed. using the centring ridges.
Burner parts dirty/damp. Clean and dry the burner
parts, making sure that the
outflow holes are open.
Main gas tap closed. Open the main gas tap.
Fault in the gas network. Check with your gas supplier.
Gas bottle or tank is empty. Connect a new gas bottle or
have the tank filled.
Wrong type of gas used Check that the gas used is
(where bottled gas is used). suitable for the appliance.
Control knob not kept Keep the control knob
pressed in long enough or pressed in far enough
far enough. between full and low.
GB 13
Faults table