Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety precautions
This product complies with the requirements of the following European Community Directives: 89/336/EC
(Electromagnetic Compatibility) and 73/23/EC (Low Voltage) as amended by 93/68/EC (CE-Marking). Overvoltage
category II, Pollution degree 2.
The following safety precautions must be observed at all times during operation, service and repair of this product to
ensure safe operation of the product and eliminate the danger of serious injury due to short-circuit (arching).
Damages resulting from failure to observe these safety precautions are exempt from any legal claims whatever.
*
Indoor use only
*
Prior to connection of the equipment to the mains outlet, check that the available mains voltage corresponds to
the voltage setting of the equipment.
*
Connect the mains plug of the equipment only to a mains outlet with earth connection.
*
Do not place the equipment on damp or wet surfaces.
*
Do not subject the equipment to direct sunlight or extreme temperatures.
*
Do not subject the equipment to extreme humidity or dampness.
*
Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or fuse housing.
*
Do not exceed the maximum permissible input ratings.
*
Conduct measuring works only in dry clothing and in rubber shoes i.e. on isolating mats.
*
Comply with the warning labels and other info on the equipment.
*
Check test leads and probes for faulty insulation or bare wires before connection to the equipment.
*
Disconnect test leads or probe from the measuring circuit before switching modes or functions.
*
Do not cover the ventilation slots of the cabinet to ensure that the air is able to circulate freely inside.
*
Do not insert metal objects into the equipment by way of the ventilation slots.
*
Do not place water-filled containers on the equipment (danger of short-circuit in case of knockover of the
container).
*
Do not operate the equipment near strong magnetic fields (motors, transformers etc.)
*
Do not subject the equipment to shocks or strong vibrations.
*
Keep hot soldering irons or guns away from the equipment.
*
Allow the equipment to stabilize at room temperature before taking up measurement (important for exact
measurements)
*
Do not modify the equipment in any way.
*
Do not place the equipment face-down on any table or work bench to prevent damaging the controls at the front.
*
opening the equipment and service- and repair work must only be performed by qualified service personnel.
Repair work should only be performed in the presence of a second person trained to administer first aid, if
needed.
Cleaning the cabinet
Prior to cleaning the cabinet, withdraw the mains plug from the power outlet. Clean only with a damp, soft cloth and a
commercially available mild household cleanser. Ensure that no water gets inside the equip-ent to prevent possible
shorts and damage to the equipment.
- Measuring instruments don't belong to children's hands -
-19-
Werbung
Inhaltsverzeichnis
