Starting The Device; Programming Functions - 2measure 220000 Bedienungsanleitung

2. FUNCTIONS
•
Outdoor and indoor temperature (°C or °F)
•
Saving min. and max. temperature
•
Expected temperature change direction
•
Freezing point
•
Clock

3. STARTING THE DEVICE

Remove the protective film from the display prior to use.
Note: To avoid operating problems pay attention to polarity of alkaline batteries at inserting them (wrong polarity of
batteries may result in a permanent damage to the device).
Remove the plastic label on the back of base station.
The thermometer will show temperature in degrees Celsius once it is started.

PROGRAMMING FUNCTIONS

4.
Selecting the temperature display unit (°C/°F)
to set the required temperature unit: degrees Celsius or degrees Fahrenheit (°C/°F).
Press
Setting the time
•
Press and hold
•
Press
•
Press the minute digits will start flashing on the display.
•
Press
•
Press to return to the normal display mode.
Minimum and maximum temperature
The minimum (lo) and maximum (hi) values of the external or internal temperature are permanently visible on the screen.
The values are displayed in the lower part of the screen.
If the main part of the screen is set to internal temperature (IN), the "lo" and "hi" indications apply to this value.
Similarly, if external temperature (OUT) is set in the main part of the screen, the "lo" and "hi" indications apply to this
value.
Cancelling the stored values
• In temperature mode, long pressing "
Display settings
⚫
The user may select which value: outside (OUT) or internal (IN) temperature, is to be shown as the main element
of the display. In order to do so, press
⚫
To switch between displaying of minimum and maximum values, permanently visible on the screen, and the
clock, press and hold
Temperature change tendencies
•
The device detects and displays the current temperature every 30 seconds.
•
If the temperature did not change within 30 seconds or increased by at least 1
upwards arrow
•
If the temperature decreased by at least 1
•
If the temperature did not change within an hour, the arrows will disappear from the screen.
Black Ice alert
•
If the outside temperature is between -3°C and 1°C (26.6°F and 33.8°F), the
begin flashing on the screen.
• symbol will disappear when the station is outside the range of -3°C and 1°C (26.6°F and 33.8°F).
The
for 3-4 seconds, the hour digits will start flashing on the display.
or to set the hour.
or to set the minute.
for 3 seconds.
.
"button for 3 seconds to clear the Hi./Lo. records.
.
o
C, the display will show a downwards arrow
5
o
C, the display will show an
.
symbol, black ice alert, will