Routine Maintenance - tau BIG Serie Bedienungs- Und Wartungsanleitung

ROUTINE MAINTENANCE

Each of the following operations must be carried out when necessary and always every 6 months.
Gate: check the general condition of the gate.
Automation system:
1 check the safety devices.
2 regularly grease the release device
EXTRAORDINARY MAINTENANCE OR BREAKAGE
If major work on electromechanical parts must be carried out, the faulty part should be removed and repaired in the workshop by the manu-
facturer's or other authorised technicians.
13. GUARANTEE: GENERAL CONDITIONS
TAU guarantees this product for a period of 24 months from the date of purchase (as proved by the sales document, receipt or invoice).
This guarantee covers the repair or replacement at TAU's expense (ex-works TAU: packing and transport at the customer's expense) of parts
that TAU recognises as being faulty as regards workmanship or materials.
For visits to the customer's facilities, also during the guarantee period, a "Call-out fee" will be charged for travelling expenses and labour costs.
The guarantee does not cover the following cases:
• If the fault was caused by an installation that was not performed according to the instructions provided by the company inside the
product pack.
• If original TAU spare parts were not used to install the product.
• If the damage was caused by an Act of God, tampering, overvoltage, incorrect power supply, improper repairs, incorrect installation,
or other reasons that do not depend on TAU.
• If a specialised maintenance man does not carry out routine maintenance operations according to the instructions provided by the
company inside the product pack.
• Wear of components.
The repair or replacement of pieces under guarantee does not extend the guarantee period.
In case of industrial, professional or similar use, this warranty is valid for 12 months.
Manufacturer:
Address:
Declares under its sole responsibility, that the product: Electromechanical actuator
for use in a: Industrial
Model: BIG
Serial number: SEE SILVER LABEL
Has been produced for incorporation on an access point (sliding gate) of for assembly with other devices used to move such an access point, to
constitute a machine in accordance with the Machinery Directive 2006/42/EC.
Also declares that this product complies with the essential safety requirements of the following EEC directives:
- 2014/35/EU Low Voltage Directive
and, where required, with the Directive: - 2014/53/EU Radio equipment and telecommunications terminal equipment
Also declares that it is not permitted to start up the machine until the machine in which it is incorporated or of which it will be a component has
been identified with the relative declaration of conformity with the provisions of Directive 2006/42/EC.
The following standards and technical specifications are applied:
EN 61000-6-2; EN 61000-6-3;
EN 12453:2000; EN 12445:2000;
The manufacturer undertakes to provide, on sufficiently motivated request by national authorities, all information pertinent to the quasi-machinery.
Sandrigo, 29/11/2017
Name and address of person authorised to draw up all pertinent technical documentation:
Loris Virgilio Danieli - via E. Fermi, 43 - 36066 Sandrigo (Vi) Italy
MANUFACTURER'S DECLARATION OF INCORPORATION
(in accordance with European Directive 2006/42/EC App. II.B)
- 2014/30/EU Electromagnetic Compatibility Directive
EN 60335-1; ETSI EN 301 489-1 V1.9.2;
EN 60335-2-103
_________________________________________
TAU S.r.l.
Via E. Fermi, 43 - 36066 Sandrigo (Vi) - ITALY
designed for automatic movement of: Sliding Gates
complete with: Electronic control unit
Type:BIG25QIQI / BIG40QI
Commercial name: AUTOMATION FOR SLIDING GATES
ETSI EN 301 489-3 V1.6.1;
Legal Representative
Loris Virgilio Danieli
15
EN 300 220-2 V2.4.1;