Cleaning The Grinder Installa On Surface; Cleaning The Casing; Cleaning The Spout System - Mahlkönig E80 SUPREME Originalbetriebsanleitung

Cleaning the grinder installa on surface

1. Switch off the grinder (On/Off switch (5) to "0") and remove the power
plug from the socket.
2. Li the grinder by the casing using both hands and place it onto a clean
surface.
3. Clean the surface and the underside of the grinder with a damp cloth
and dry the surfaces.
The surfaces must be dry and free of oil and grease.
4. Place the grinder back onto the cleaned surface.

Cleaning the casing

1. Switch off the grinder (On/Off switch (5) to "0") and remove the power
plug from the socket.
2. Use a brush to clean the following grinder components:
• the spout (13),
• the portafi lter intake (12),
• the start bu on (11),
• the portafi lter support (10),
• the screws (8) for adjus ng the portafi lter support (le and right).
3. Pull the collec ng tray (9) forward and out of the grinder.
Wipe the casing and the collec ng tray with a damp cloth as required,
but at least once a week.

Cleaning the spout system

The manufacturer recommends using a brush with nylon bristles
to clean the spout system.
1. Pull the spout (13) downwards out of the lock (see Fig. H).
2. Carefully clean the outlet on the grinder casing with a brush.
3. Clean the spout with a damp cloth and then dry it.
Be careful not to damage the surface of the spout.
Fine scratches can nega vely impact the grinding result, as
espresso grinds adhere to the scratches, which can, in turn, lead
to fl uctua ons in dosing amount.
E80 SUPREME | EN
61