Using The Led Standby Function; Storage And Transport - SCHÖLLY FIBEROPTIC FLEXILUX 200 Gebrauchsanweisung

4.8

Using the LED Standby Function

4.9

Storage and Transport

Instructions For Use | 13 - Mar - 2020 | Version: H
Using the LED standby function
Use the LED standby function if you want to briefly dim the light to the minimum
level.
Proceed as follows:
1. To set the light supply at 5 %, tap the LED standby button.
The LED output is reduced to 5 %; the device remains switched on.
2. To set the light supply to its previous value, tap the LED standby button once
more.
The LED switches back on immediately and supplies light at its previous
setting.
The LED standby function has been used.
To prevent the device from falling when being transported on the equipment cart,
secure with a tension belt.
Figure 4-1: Device on equipment cart, secured with tension belt.
Store the device in a dry, well-ventilated, temperature-controlled room, where it is
protected from dust.
Switch off the device prior to storage and remove the power cord and acces-
sories.
When placing into storage or storing temporarily, make sure that the device can-
not be damaged by its surroundings.
To avoid damage, keep out of direct sunlight and away from radioactivity and
strong electromagnetic radiation.
The ambient conditions for transport, storage, and operation are described in
section 7.2.
4.8 Using the LED Standby Function
4 Operation
Page 65 of 76