Switching On And Off, Separation From The Power Supply - SCHÖLLY FIBEROPTIC FLEXILUX 200 Gebrauchsanweisung

4.4

Switching On and Off, Separation from the Power Supply

Instructions For Use | 13 - Mar - 2020 | Version: H
4.4 Switching On and Off, Separation from the Power Supply
Switching on the device
Proceed as follows:
1. Switch on the device at the front.
Device does not switch on?
The main switch on the rear is switched off.
Switch ON at the main switch.
After approximately 10 seconds, the device is ready for operation.
The ON / standby button on the front is illuminated white.
The device is on.
Switching off the device
Proceed as follows:
1. Switch off the device at the front.
The device switches to standby mode.
The ON / standby button on the front is illuminated green.
When the device switches back on, the light output depends on the setting pri-
or to the switch to standby mode:
If the light output was 85 % or higher when in standby mode, it will be reduced
to 80 % when switched back on. If lower than 85 %, the light output will be the
same as prior to the switch to standby mode.
2. To switch off the device completely, switch off at the main switch on the rear.
The device is off.
Separating the device from power
Proceed as follows:
1. To separate the device completely from its power supply, disconnect the
power cord. The appliance coupler is considered as disconnecting device.
Make sure that the rear of the device is accessible at any time.
The device is completely separated from the power supply.
4 Operation
Page 63 of 76