Battery Charging - Viper AS710R Bedienungsanleitung

USER MANUAL
4. Turn on the key switch.(E5)
5. Turn on the brush motor switch.(E3)
6. Depress the driver pedal slowly (C6) and turn steering wheel (A14) to forward. The speed can
be controlled by a dial (E6), turning left decreases speed, and turning right increases speed.
And to reverse, you can press the switch (E7).
7. Adjust amount of solution flow by pressing the solution/water adjustment button. (D5)
8. As long as you turn on the key switch (E5), you can charge the cell-phone through the USB
charging interface (A11).
9. You may press the horn (E9) for alert in case of encountering unexpected crowds or heavy
crowds.
When battery indicator is red and flashing, do not continue to operate the machine;
otherwise, this will cause harm to the batteries or machine. Recharge batteries.
Regularly view the clear tube (C7). If tank runs empty, turn off the brush switch, solution
switch and raise the brush head. Keep the squeegee down and continue to vacuum until
all dirty water is picked up.
Regularly view the filter (D3) and clean it by unscrewing the transparent cover.
If the squeegee assembly leaves streaks on the floor, raise the squeegee off the floor and
wipe the blades down with a damp cloth.
Do not use your fingers to wipe or remove debris from the blades, as injury may occur.
When normal circumstances, the brake on the drive motor is applied. When all of the
safety system are "go", and the drive pedal is depressed, the brake will release and the
machine will move.
In special circumstances (dead batteries, no batteries or major malfunction), the brake
can be manually released so the machine can be pushed. Pull the brake bracket put (it will only
move about 1/4 inch) and use an allen wrench or screw driver as a wedge to hold the bracket
out.
Please use approved chargers to charge the batteries, while the machine is not equipped
with on-board battery charger.
For good machine performance, always keep batteries charged at all times. Do not let them
be in an over-discharged condition.
When charging the machine, make sure the transparent cover is open.
Charge the batteries when the red indicator (E11) on.
1. Charge the machine in a well-ventilated area.

BATTERY CHARGING

11
ENGLISH