Energy Saving Tips; Setting The Temperature - Dometic CoolMatic CRE-Serie Montage- Und Bedienungsanleitung

Using the refrigerator
I
NOTE
• Before starting your new refrigerator for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 29).
• Do not use force to press the flap of the freezer.
• Do not pull out the dividing wall if there is ice in the freezer.
• Do not remove the sticker which covers the control element (fig. 4,
page 4).
8.1

Energy saving tips

• Choose a well ventilated location which is protected from direct sunlight.
• Allow hot food to cool down first before you put it in the refrigerator.
• Do not open the refrigerator more often than necessary.
• Do not leave the door open for longer than necessary. If the door is left open for
more than 5 minutes, the light starts to flash.
• Defrost your refrigerator as soon as a layer of ice forms.
• Avoid unnecessarily low temperature settings.
8.2 Switching on the refrigerator
➤ Switch the refrigerator on by pressing the
I
NOTE
8
After switching on, the refrigerator needs some time before the com-
pressor starts up.
8.3

Setting the temperature

➤ Press the
button repeatedly until the desired temperature level is set.
The more LEDs light up above the button the lower is the temperature level.
To switch from the last level to the first level press the
26
button.
button again.
CRE
EN