Description Of The Control Buttons - Qlima EFE 2018 Gebrauchsanweisung

• Installing the heater to a wall can be viewed on a video. Please check:
• For installation of the appliance, care must be taken not to damage concealed cables in
the wall. Be careful while drilling the holes.
• The heater is heavy and voluminous: when lifting and mounting the appliance and/or the
glass surround always do this with at least 2 persons
• This appliance is designed to be permanently fixed to a wall at a minimum height of
Fig. 3
300mm. The wall bracket must be fitted horizontally and the electrical cable routed to the
bottom right of the heater.
• A height of 600mm from bottom of heater to floor is recommended for optimum viewing
of fuel bed (see Fig.3 for recommend fixing dimensions).
• Keep top of heater at least 1500mm away from ceiling or other objects for optimum heat
ventilation.
Fig. 4
• For optimum viewing, mark the top four screws fixing positions on wall in accordance with
the recommend fixing dimensions- see Fig.4..
• Mount the long wall bracket using the plugs and screws provided.
• Carefully lift the heater up ensuring that the top rear ledge of heater engages the long
wall bracket (see Fig.4 in circle) and is sitting centrally.
• Gently bring the heater level with the wall.
• Mark the 2x bottom holes position for the lower small/short support bracket (see Fig.5,
marked with arrow pointer), remove the heater.
Fig. 5
• Mount the small/short wall bracket using the plugs and screws provided.
• Refit the heater to the long wall fixing bracket.
• Mount the bottom small/short wall bracket to the wall and use the screws provided to per-
manently fix the heater in place.
• Unpack the pebbles from the bag and place them along the light unit in the desired posi-
tion.
Fig. 6
• Place the front glass surround over the front of the fire aligning the slots in the brackets at
each side of the glass panel with the lugs on the sides of the fire-see Fig.6.

DESCRIPTION OF THE CONTROL BUTTONS

The appliance can be controlled with the remote control and the buttons on the appliance.
In stand-by modus the on/off symbol
the timer symbol
The timer function can be activated with the timer button.
On the appliance the date/time, temperature and brightness can be set. The heating function
only works if the set temperature
is higher then the room temperature.
Manual control
• Press the on/off button to turn the appliance on. Press and hold this button 5 seconds to
change the brightness. If you want to use the heating function with the light effect, push
the required button (900W / 1800W). With these buttons the function can also be turned
off.
4
58
will be on. When the timer function is enabled
will be on.