Ducati 996R 2001 Anleitung- Und Instandhaltungsheft Seite 89

Seat catch and helmet hook
Opening (fig. 14.1)
Fit the ignition key into the lock (1) and turn the key
clockwise.
Pull gently the tail guard (2) outwards and lift it until it
rests onto the fuel tank.
On the rear end of the compartment underneath the
seat, there is the helmet fastening cable. Insert the cable
(A) into the helmet and insert the ends of the cable into
the hook. Leave the helmet hanging outside (fig. 14.2)
and refit the seat.
Warning
This system is intended to lock your helmet safely
when you park your motorcycle. Never leave the helmet
hanging from the hook when riding or it may get in the
way and make you lose control of the motorcycle.
Inserting the cable under the subframe from the left side
will enable you to lock the seat.
With the cable in any other position, the seat will not lock
properly.
Closing
Arrange all parts properly inside the compartment under
the seat.
Lower the tail guard to its horizontal position. Press on
the rear end (2) of the seat until you hear the catch click.
Pull the tail guard gently up to make sure it is firmly
secured to the frame.
0
0
2
1
1
1
E
fig. 14.1
fig. 14.2
21