Maintenance - DeWalt DW304 Bersetzt Von Den Originalanweisungen

Pocket Cuts
1. Measure and mark the required pocket cut.
2. Using a narrow saw blade rest the bottom of
the saw shoe on the workpiece and make sure
that the blade is positioned on the cutting line.
If necessary, e.g. in confi ned spaces, use the
outer edge of the saw shoe as your guideline.
3. Switch on the tool and feed the blade into the
material at full speed, holding the tool fi rmly
against the workpiece.
Cutting Metal
When cutting thin metal always stabilize the
workpiece with wood on both sides. This guarantees
clean cuts and prevents damaging of the material.
For long, straight cuts draw a line on the workpiece.
Apply a thin film of lubricant along the cutting line,
switch on the tool and follow the cutting line.
Cutting Plastics
Always work at reduced speed. Carry out a test cut
to check whether the material is sensitive to heat.
Cutting Masonry
WARNING: When sawing asbestos
cement hazardous dust may be
produced. Follow the statutory
guidelines and observe the
recommendations issued by the
asbestos cement manufacturers.
Sawing Up to a Projecting Edge
(fi g. 4)
Using a conventional blade installed upside down,
cut up to the projected edge.
Parallel Cutting (fi g. 5)
With the blade installed in the horizontal orientation,
the tool can be used for parallel cutting close to
floors, walls or ceilings.
Make sure that the saw shoe remains in contact
with the workpiece at all times.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Dust Extraction
When the tool is used indoor for extended periods
of time, use a suitable dust extractor designed in
compliance with the applicable Directives regarding
dust emission.
Lubrication
If the tool will not be used for a long period of time,
coat the saw blade with a little oil (e.g., machine oil).
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
EN G LI SH
WALT, have
E
25