HomeMatic IP HmIP-FAL230-C10 Installations- Und Bedienungsanleitung Seite 63

Configuration via the Homematic IP Wall Thermostat
• Select the
wheel and confirm by pressing the control wheel
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the re-
quired floor heating actuator using the control
wheel.
• Please define if you want to configure the device
parameters ("UnP1/UnP2") or the channel param-
eters ("ChAn").
All the settings that are made under "UnP1/UnP2"
will be applied to the entire device. All settings
that are made under "ChAn" will be applied to the
single channels of the device.
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc. ac-
cording to the following table.
symbol by turning the control
63