Intended Use - Conel DRAIN Gebrauchsanleitung

Correct installation:
Only route drainage points below the flood
level to a backflow stop. Connect downpipes
for surface water downstream of the backflow
stop in flow direction.

1.2 INTENDED USE

When wastewater drains overfill, e.g. following heavy rain, blockages or pumping station
failures, wastewater can backflow and cause damage to buildings. Backflow stops are
designed for domestic use and protect buildings against water damage.
DRAIN
backflow stops:
Backflow stops are intended for installation in exposed pipelines.
/
Single backflow stops (type 0) are tested to EN 13564-1 and approved for rainwater
/
recycling systems which have overflows connected to the storm water drainage line.
Double backflow stops (type 2) backflow stops are tested to EN 13564-1 and approved
/
for continuous piping systems for wastewater free of faeces.
NOTICE Hazardous substances may not be drained:
Solids, e.g. ashes, glass, sand, textiles, cardboard
/
Corrosive substances, e.g. acids, lyes, salts. Condensate from condensing boilers is acidic
/
and must be neutralised before.
Foaming substances, e.g. cleaning, dishwashing and washing agents in large quantities
/
Poisons, e.g. pesticides, pest control agents
/
Oil and grease
/
INSTRUCTIONS FOR USE
DRAIN / FOR YOUR SAFETY
Backflow level
Netzbetrieb Akkubetrieb Blinkleuchten Dauerleuchten
Betriebsverschluss zu Rückstau Ausschalten
Akkustörung Motorstörung Betriebsverschluss fährt auf/zu gleichzeitig drücken. Einschalten 2. Tasten (links/rechts) 5 Sekunden lang 1. Netzstecker ziehen
zu starten. Initialisierung stecken um 3. Netzstecker ein-
1x: Ton aus 2x: Grundeinstellung nach Störung Test Betriebsverschluss 1x: Zufahrt 2x: Auffahrt
27