Dometic COOLFREEZE CDF18 Bedienungsanleitung Seite 20

Troubleshooting
10 Troubleshooting
Fault
Device does not
function, LED does not
glow.
The device does not
cool (plug is inserted,
POWER LED is lit).
The device does not
cool (plug is inserted,
ERROR LED flashes).
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
ERROR LED flashes for
longer than 2 minutes,
as follows: 3 flashes,
pause, 3 flashes,
pause, ...
11 Disposal
➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
20
Possible cause
No voltage is flowing
from the DC power
socket in your vehicle.
No voltage present in
the AC voltage socket.
Defective compressor.
Battery voltage is too
low.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The DC fuse inside the
device has blown.
The vehicle fuse has
blown.
Defective device.
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to the
DC power socket.
Try using another plug socket.
This can only be repaired by an
authorised repair centre.
Test the battery and charge it as needed.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the plug fuse
(12/24 V)" on page 18.
This can only be repaired by an
authorised repair centre.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
This can only be repaired by an
authorised repair centre.
CoolFreeze
EN