Troubleshooting Guide; Warranty - MONDELIN LEVPANO I Bedienungs- Und Wartungsanleitung

RECOMMENDATIONS :
•
Do not overlap the cables when refitting.
•
Take care to make the position of each part visible before removing it so
as to limit the risks or errors.
E. TRANSPORTING THE LEVPANO
1. Transport from a building site to the next one
In order to make transport from a building site to the next one easier,
the LEVPANO® is broken down into 2 or 3 elements depending on the
model:
The frame equipped with 2 rollers at the bottom of the
-
column makes transport easier O1
The head and beam assembly
-
The working platforms (LEVPANO® I)
-
F. TROUBLESHOOTING GUIDE
If there is apparently a fault on the LEVPANO®, go through the following points before asking for it to be repaired, taking all necessary safety
precautions (wear a helmet, goggles and gloves).
If the device is locked in the raised position, make sure that the plasterboard panel is fixed at the ceiling or secure this by means of supports,
before attempting to unlock it.
DIFFICULTY
Device locked in the raised position
Comes down freely without brake
Goes up with difficulty
The device does not lock in one of its adjustment
positions
NOTE :
If the problem persists, contact the After-Sales Department.
For any spare parts order, refer to the exploded view, page 1 for the LEVPANO
G. WARRANTY
This device is guaranteed against manufacturing defects for 5 years from its date of purchase mentioned on the retailer's invoice.
Claims under this warranty can only be taken into account if the instructions given in the user's manual and more particularly in paragraphs A, B,
C and D are strictly complied with.
Deteriorations caused by normal wear (wheels, pulleys, cables, winch, arm shoes with spring, arm pads), abnormal use, incorrect
servicing/maintenance or overload, are not covered by the warranty.
Failure resulting from a use other than that for which the LEVPANO® has been designed, i.e. the fixing of horizontal plasterboard at the ceiling,
under pitches or vertically on partitions, cannot be repaired under the warranty.
H. ACCESSORIES
The LEVPANO® can be equipped with the following accessories:
Steam protective unwinder ref. 513300 P1
Support platform ref. 513200 P2
I. END OF LIFE OF THE PRODUCTS
The metallic parts must be separated from the plastic components in order to ensure recycling in accordance with the regulations in force.
®
POSSIBLE CAUSE
- Brake locked
- Cables stuck and/or damaged
- Columns locked
- Excess winch grease
- Tightening of the brake
- Lock washer inoperative
- Presence of foreign matter
- A lock remains blocked
- The beam's pivoting discs are blocked
Weight of the various elements :
Frame (equipped with 2
transport rollers)
Head and beam
Working platforms (LEVPANO® I)
The shape given to the transport handle on which the winch is fixed
enables also the operator to carry the frame assembly on the shoulder.
2. Transport on the building site
Depending on the model, the LEVPANO® is equipped with three or four
125 mm dia. wheels, two of them are equipped with brakes.
The transport handle on which the winch is fixed enables the operator
to guide the LEVPANO®.
Undo the crank handle and put it back in contact
Check the passage of the cables and their condition
Check the cleanness of the columns
Degrease the lock washer and the support
Put the crank handle and the lock washer in contact
Check the condition of the washer
Clean the device
Clean the locks
Loosen the pivoting discs, grease the sides in contact and
then tighten the discs back, complying with an operating play

I or page 3 for the LEVPANO
6
LEVPANO® I LEVPANO® II
30.9 Kg 28.2 Kg
14.9 Kg 14.9 Kg
6 kg
CORRECTION

II.