Getting Started - sylvac SCAN 52 Kurzanleitung

1 GETTING STARTED

1.1
Unpacking and
installing the machine
1.2
Cable connections
2 OVERVIEW AND PART SETUP
2.1
Description
of the machine
6
The machine must be installed on a flat surface, ca-
pable of supporting its weight (105 kg/ 231 lbs).
The SYLVAC-SCAN 52 REFLEX-Click will be lifted
on both sides. Forklift lifting straps can also be
used to move the machine properly.
Strict adherence to your local and general safety
rules is essential to prevent personnel injury.
All cable connections must be made with the ma-
chine switched off.
The wiring scheme below shows a typical configu-
ration and may vary according to the host computer
used. The physical position of each connection to
the chosen computer will depend on its properties.
A
C, E, F
D
B
A Mains supply
B RS232 cable (command of the motors)
C USB cable (linking the machine)
A
B
D
Never attempt to modify the voltage of the com-
puter/controller. If the indicated voltage does not
match that of your local mains supply, call your
SYLVAC's agent or retailer.
C
B
D Screen cable
E Keyboard cable
F Mouse cable
A Clamping handle
B Headstock (rotating), Morse 2 taper
C
E C Extraction device
F D Morse 2 taper
E Tailstock
F REFLEX-Click button
G
G ON/OFF switch
Before connecting both the computer
and monitor to the mains, check the
voltage on the data plate of each unit.
A