Introduction; Getting Started - sylvac Hi Cal 300 V2 Bedienungsanleitung

Introduction

The Hi_Cal height gauge has been designed to work on small flat reference
surfaces such as granite or scraped cast iron plates. A number of technological
innovations make this instrument very suitable for easy, fast and reliable
measurements. It offers the following advantages :
• Very low measuring force (0.3N)
• Excellent repeatability
• Fully motorized probe displacement. The movement speed is proportional
to the pressure on the UP/DOWN button. The probe automatically tracks
profiles and maintains a constant measuring force : measuring diame-
ters is, therefore, fast and precise
• Reduced weight for easy handling
• Very easy to operate and versatile: can be used both in the workshop and
laboratory
• Two lines display, enabling viewing of diameter and centerline simultaneously

Getting Started

Simply remove the transport fixing part by pulling it upward, then fix the probe on
the support: instrument is ready for measuring. Keep the transport clamp and the
locking system for any subsequent transport. (see commissioning diagram p.2)
Important: Always check the fixing of the probe and the probe constant
value before measuring.
Connect the AC/DC adapter, and check the status lights:
Top light :
Bottom light :
Remark: initially, or after a long period without use of the instrument, battery
loading may take a few minutes before the instrument is ready.
ON
Fast charge (2 hours)
OFF
Holding charge. This is a safe charge mode to avoid
battery losses in case of continuous AC/DC power
connection
ON
Power connected
E
7