Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.2
The part to be measured is clamped between the
Part setup
headstock and tailstock.
1 Move the tailstock so as to accommodate the part
2 Insert the part.
3 QUICK START RUNNING SYLVAC-REFLEX SCAN
3.1
1 Turn on the machine using the ON/OFF switch.
Starting up
2 Start the computer.
3 Start running SYLVAC-REFLEX Scan once each
4 Your screen shows now the window below.
5 Since your system must be calibrated prior to any
6 On completion of the calibration process, your
3.2
Regularly cleaning the machine as instructed in the
Maintenance
manual available from the DVD provided with this
feature is important.
over its whole length.
peripheral device is initialized. Before doing so, it
is advisable to wait at least 30 seconds after
Win- dows could be started up.
measurement, press the REFLEX-Click button on
the front face of the machine and get the message
prompting you to confirm the requested calibra-
tion.
part can be measured. Note that the REFLEX-
Click mode is selected by default.
3 Move the red clamp handle laterally to the left
while rotating this handle through 180° to make
sure the part is held firmly.
7 Press the REFLEX-Click button once again, and
get the first measurement results after a few
seconds.
8 Press the Composer button to create a part pro-
gram that will let you enter the nominal values to
be compared with the measured values.
9 As soon as all desired changes are entered, press
the REFLEX-Click to save your programme prior
to start it up.
It is essential to clean and lightly lubricate the head-
stock (female taper and plate), tailstock (female
taper) and all accessories so as to prevent these
components from corrosion.
7
Werbung
