Inhaltsverzeichnis
Werbung
WARM START
(Engine still warm from previous use)
(1) Pull starter handle until saw starts.
NOTE
You must depress the safety lock on top of the
handle (Figs. 14 & 15) to be able to engage the
trigger. The trigger will not function without
depressing the safety lock.
RUNNING-IN THE CHAIN
Running-in the chain stretches and fully lubricates
the chain for optimum longevity and performance.
Start the saw and run it at three-quarter speed for
approximately 10 minutes or until the bar and
chain begin to smoke.
Now turn off the saw. The chain has reached its
operating temperature. You will notice the chain
now sags from the bar. (Fig. 16) Before readjusting,
allow the chain to cool down for three to five
minutes, or until it is cool enough to touch.
Once it is cool enough to handle, readjust the
chain to the proper tension. See Page 15 for
chain tension adjustment.
NOTE
We recommend you repeat this entire chain
running-in procedure at least once more.
CUTTERS EDGE FIRE RESCUE SAWS/
Fig. 14 Safety Lock
Fig. 15 Depressing the Safety Lock
Fig. 16 The chain will sag when hot
22
Werbung
Inhaltsverzeichnis
