Inhaltsverzeichnis
Werbung
THE MOMENTARY CONTACT SWITCH
Before starting the saw, you should know how
to stop it. The Cutters Edge Fire Rescue Saw is
equipped with a momentary contact switch that
is always in the "on" position (Fig 12). To stop the
saw, push and hold the momentary contact
switch to the right. This kills the saw. When
released, the switch will snap back into the "on"
position automatically.
STARTING THE SAW
IMPORTANT!
Before starting the saw, it is important to note
that you should not run the saw at full throttle
until after breaking in the engine.
To start the saw, place it on the ground. Grip the
top handle firmly and step on the outer edge of
the back handle. (Fig.13)
IMPORTANT! CHECK THE CHAIN
BRAKE BEFORE STARTING
Do not start the saw with the chain brake
engaged. Be sure the chain brake is disengaged
by pulling back the chain brake handle until
it contacts the front of the full wrap handle.
(See Fig. 3 on page 11).
COLD START
(1) Pull out the choke knob*. This automatically
locks the throttle trigger and the carburetor into
their optimum positions for starting. If you do
not touch the throttle during starting, there is
no possibility of flooding.
(2) Grasp the starter handle and pull sharply
upward a few times until the engine catches.
(3) Push the choke in.
(4) Pull the starter handle again.
The engine will start.
(5) Let saw run at fast idle for 5 seconds.
(6) Quickly squeeze and release the throttle
trigger to set the idle.
* We recommend storing the saw with the
choke knob pulled out.
CUTTERS EDGE FIRE RESCUE SAWS/
Fig. 12. Momentary Contact Switch
Fig. 13. Proper starting position
20
Werbung
Inhaltsverzeichnis
