Installation Instructions - Climadiff CLV Serie Gebrauchsanweisung

The name plate attached to the inside or rear of the appliance (depending on the model)
includes all the information specific to your wine cellar.
We recommend that you make a note of its serial number in this booklet prior to installation,
so that you can refer to it later (technical work, request for assistance, etc.)
Once it is installed and loaded, access to it is not so easy.
CAUTION: No assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using your wine cellar

Remove the inner and outer packaging. Remove your wine cellar from the transport pallet
by unscrewing the two screws on the frame at the back of the device.

Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This
will reduce the possibility of malfunction of the refrigeration circuit due to transport.

Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar
Your wine cellar must be positioned in a room with an ambient temperature between
+10°C and +32°C. Alternatively, if the cellar is fitted with the winter system, the range is
extended to 0°C to 32°C.
Installing your wine cellar

This unit is intended for free-standing installation only. It must never be built-under or
built-in. For proper operation of the appliance, it is imperative to allow good air
circulation around the unit. We do not accept any liability instance of non-compliance with
the installation instructions.

Position it in a place with sufficient strength to support its weight when loaded.

To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight,
and do not place it in a room which is too cold.

Plug the cellar into a single outlet.

Screw the stopper supplied inside the wine cellar to maintain a 10 cm minimum distance
between the back of the cellar and the wall in front of it is placed. Ensure that your wine
cellar is perfectly horizontal, then slightly raise the two front feet (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and
vibration, and will ensure that the door seals perfectly.
59