Herunterladen Inhalt Inhalt Diese Seite drucken

GEA AVR 963 Betriebsvorschriften Seite 9

Inhaltsverzeichnis

Werbung

9 ∙ BETRIEBSVORSCHRIFTEN / OPERATING INSTRUCTIONS
Absperrventile / Shut-off Valves
Wartung
Maintenance
7.
Zur Dichtheitskontrolle Spindel in Mittelstellung brin-
gen, Deckelbereich mit Schaummitteln einpinseln.
Auswechseln der Flachdichtungen S und R bzw. der
Spindel kpl.
1.
Ventil bis Anschlag öffnen. Deckelschrauben
(ISO 4762) lösen.
! Auf eventuell austretendes restliches Kältemittel
achten. Bis zum völligen Druckausgleich
Deckelschrauben lose im Gehäuse belassen. Erst
danach völlig herausschrauben.
2.
Deckelschrauben herausschrauben und Deckel
einschließlich Innenteile am Handrad herausziehen.
3.
Handrad von der Spindel abschrauben und die
Spindel aus dem Deckel herausdrehen.
4.
Flachdichtring R herausnehmen und ersetzen.
5.
Sitzdichtung entfernen und durch Neue ersetzen.
Vor der Montage sind alle Einzelteile der Ventile zu
reinigen, die Spindel und der Deckel einzufetten.
Anschließend wird noch ein Flachdichtring K eingelegt,
der Deckel aufgesetzt und mit den Schrauben
gleichmäßig und über Kreuz angezogen.
DN
M
SW
Nm
Nm
GEA AWP GmbH
Armaturenstr. 2
17291 Prenzlau, Germany
DN
M
SW
Anzugdrehmoment für 8.8-Schrauben / tightening torque for 8.8 screws
Anzugdrehmoment für A2-70-Schrauben / tightening torque for A2-70 screws
Tel +49 3984 8559-0
Fax +49 3984 8559-18
7.
For leakage test move the stem into central position
and coat the cover area with a foaming agent.
Replacing the Flat Seals S and R Resp. the Complete
Stem
1.
Open the valve up to the limit stop. Loosen the cover
screws (ISO 4762).
! Remnants of refrigerant might leak. The cover
screws should be kept loosely in the body until the
pressure has equalized totally. Only then should it be
unscrewed completely.
6-15
20
6
8
5
6
2.
Unscrew cover screws, grab the handwheel and pull
out the cover including internal parts.
3.
Screw the handwheel from the stem and turn the
stem out of the cover.
4.
Remove the flat sealing ring R and replace it.
5.
Remove the seat sealing and replace it.
Before assembly, clean all component parts of the valves;
grease stem and the cover.
Afterwards, insert another flat sealing ring K, put back the
cover in place and tighten by the screws evenly and
crosswise.
6-15
6 x 18
8 x 20
ISO 4762
5
10
6
info@awpvalves.com
awpvalves.com
20
6
25
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Avr 96496300964009631096410

Inhaltsverzeichnis