Display Adjustment & Mounting - NEC MD205MG-1 Installations- Und Wartungshandbuch

Display Adjustment & Mounting
Raise and Lower Display Screen
The display may be raised or lowered in either portrait or landscape
mode. To raise or lower the screen, place hands on each side of the
display and lift or lower to the desired height.
Handle with care when raising or lowering the display
NOTE:
screen and avoid pinching your fingers.
Screen Rotation
Before rotating, the screen must be raised to the highest level to avoid
knocking the screen on the stand or pinching your fingers. To rotate the
screen, place hands on each side of the display screen and turn clockwise
from landscape to portrait or counterclockwise from portrait to landscape.
To rotate the orientation of the OSD menu between landscape and portrait,
refer to the "OSD" section, "OSD Rotation" function.
Tilt and Swivel
Grasp the left and right sides of the display screen with your hands and
adjust the tilt and/or swivel as desired.
NOTE: Handle with care when tilting the screen.
Remove Stand for Mounting
This stand can be removed in order to mount the display using
an alternate, VESA approved, mounting method.
1. Disconnect all cables.
2. Place hands on each side of the display and lift up to the
highest position.
Rotate the screen 90° counter clockwise to the landscape position.
3. In the landscape position, place the display face down on a nonabrasive surface.
Place the screen on at least a 36mm platform so that the stand is parallel with the surface
(Figure S.1).
4. Remove the 4 screws connecting the display to the stand (Figure S.2).
NOTE: Reverse the process to reattach stand.
Handle with care when removing monitor stand.
Flexible Arm Installation
Use a flexible arm that is strong enough to support the weight of the display (approx 7.3kg).
Use the 4 screws that were removed from the stand to attach the flexible arm to the display
(Figure S.3).
NOTE: Use the original screws (4 pcs) when mounting to avoid damage to the display and
stand. To fulfill the safety requirements the display must be mounted to an arm
which guaranties the necessary stability under consideration of the weight of the
display. The display can only be used with an approved arm (e.g. GS mark).
01_MD205MG-1_INSTALL_EN.P65 5
Figure S.1
English.5
7/5/08, 10:09 AM
Figure S.2
36mm
Figure S.3