Bestway 61062 Bedienungsanleitung Seite 3

SAVE THESE INSTRUCTIONS
Assembling of the boat
NEVER USE HIGH PRESSURE AIR TO INFLATE INFLATABLES. THIS CAN
DAMAGE YOUR PRODUCT AND VOID YOUR WARRANTY
• Inflate the air chambers with a HAND air pump.
An inflation scale is provided with the product. Inflate the product until the printed
scale is charged up to the same level as that of the supplied scale. (refer to the
table and illustrations below)
Caution: Under and over-inflation of the boat will result in safety hazards. It is
better to check the pressure of the boat each time before use. If you use another
pressure gauge, the boat pressure should not be more than the data given on the
builder's plate.
• Never stand on or rest objects on the boat during inflation.
• Inflate the bottom chamber and other accessories such as the seat until it is stiff
to the touch, but NOT hard.
• Extended exposure to sun can shorten the lifespan of your boat. We suggest not
leaving boats in direct sunlight for more than 1 hour after use.
Item Product Inflated Size
61078 / 61099 1.55m x 93cm (61'' x 37'')
61062 / 61100 / 61108 1.88m x 98cm (6'2'' x 39'')
61102 2.32m x 1.15m (91'' x 45'')
Inflated Size Inflated Size
Deflated Size
Chamber 2
Chamber 3
5.4cm
10cm
11.3cm
10cm 5.4cm
11cm
5.4cm
10cm
11.1cm
Oars Installation
For 61062, 61078, 61108, 61102
Note: When the oars are not in use, lock the oars into the Oar Clasps to avoid
damage.
Note: All drawings for illustration purpose only. May not reflect actual product.
Storage
1. Remove the Oars from the oarlocks.
Note: Keep all accessories for future use.
2. Carefully clean the boat using a mild soap with clean water.
Note: Do not use acetone, acid, and/or alkaline solutions.
3. Use a cloth to gently dry all surfaces.
Note: Do not dry the product in direct sunlight. Also, never dry with equipment
such as electric blowers. Doing so will cause damage and shorten the boat's life
span.
4. Deflate the hull chambers. Deflate all the hull chambers at the same time so the
air-pressure drops simultaneously.
This will prevent damage from occurring to the boat's inner structures. Next,
deflate the floor.
5. Fold the boat from front to back to remove additional air. You can also use a
pump to drain any remaining air.
Repair
1. If there is a small puncture, repair it according to the instructions on the repair
patch.
2. If the hole is too big to be repaired with the provided patch, purchase a Bestway
repair kit or send the boat to a speciality shop to make the repair.
Registration (For US/Canada customers only)
If you need to register your boat, please have the boat Hull Identification Number
and model name ready and then visit www.bestwaycorp.com/support to obtain
your Certificate of Origin, or you can send e-mail to
service@bestwaycorp.us for the Certificate of Origin.
PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO
THE NEW OWNER WHEN YOU SELL THE CRAFT.
3