RCD TEST
1
OPERATION
TIMER
1.Plug into power source, adjust power switch to "ON" (-)
position. The sand filter will begin working immediately.
2.Adjust power switch to "OFF" (0) position. The sand filter
will stop working immediately.
3.After turning on, you can adjust work time, rest time and
cycle time by turning the knob to desired position. See the
table below for more details.
4.When the timer knob is moved into new position, the filter's
previous cycle
automatically cancels so
new cycle can begin.
5.Each time the filter is
powered on or restarted,
a new cycle will begin
based on timer knob
position.
NOTE: If the knob is
adjusted to the 24-hour
position (24), the sand filter will work continuously without any
rest period.
2
11
3
4