Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Bestway 58499 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für 58499:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

release the remaining water.
4. Disconnect the two Hoses from the pool and the sand filter.
5. Completely spill the sand out of the tank and dry all
components.
6. Move away sand filter from pool area, store the sand filter
in a dry indoor location out of child's reach.

TROUBLESHOOTING

Problems
- Sand is too small
- Move the control valve from the
Sand is flowing
to the pool
- The level of the sand is too high
- The skimmer is broken
- Stopper plugs were not removed
- Air was not released
- The control valve is set to Closed
No water flow
- The strainer is blocked
- Sand filter broken
- Dirty filter
- Calcified sand bed
Excessive filter
- Insufficient backwashing
pressure
- The pressure gauge is broken
- Control Valve is set between two
Control Valve leaks
from the port D
- The gasket is broken
- Washer of the connectors not in place
Connectors leak
- Washer of the connectors broken
- Loose Hoses
Probable Causes
backwash to the filter function without
stop the sand filter
functions
- Recommend 0.45 mm to 0.85 mm #20
silica sand
- Stop the sand filter every time set the
control valve
- Check if the level of the sand is between
the marked "MAX" and " MIN" on the
collector hub
- Replace the skimmer
- Remove the stopper plugs and insert the
debris screens
- Release the air
- Set to filter function
- Clean the strainer
- Call for service
- Backwash
- Inspect sand and change if necessary
- Backwash until water runs clear
- Replace the pressure gauge
- Set to one function
- Replace the gasket
- Reposition the washer
- Replace the washer
- Tighten them
17
Solutions

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis