Bestway 58499 Gebrauchsanleitung Seite 14

• When the Control Valve is set to the Backwash, Rinse, or
Drain position, water will discharge from Port D on the
Control Valve.
• Do not switch on or operate the sand filter with the Control
Valve set to the Closed function or it will seriously damage
the sand filter.
• Do not set the Control Valve between two functions, or it will
lead to leaking.
• To avoid water leakage, screw the Port D Cap onto the
Control Valve Port D before operating the filter or circulate
function.
AIR RELEASE
Press down the control valve handle and wait untill the water flow
from Port D to release the air.
NOTE: It is important to repeat this operation
every time you start the pump after
winterizing, maintenance and backwashing
the sand bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the pump for its
first use and to wash the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash
function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs
clear.
3. Switch off the sand filter and set the Control Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This circulates
water backwards through the sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
need to replace.
Switch off the sand filter immediately if water levels near the pool's Inlet
and Outlet valves.
This procedure removes water from the pool, which you'll
14
Backwash Rinsing