Bestway 58499 Gebrauchsanleitung Seite 8

ASSEMBLY
1.Carefully remove all components from the package and check
to ensure nothing is damaged. If equipment
is damaged, immediately notify the retailer
from where the equipment was purchased.
2.The sand filter should be placed on solid, level
ground, preferably a concrete slab. Position
the sand filter so the Ports and Control Valve
are acces sible for operation, servicing and winterizing.
3.EN60335-2-41 TEST standard requires the sand filter must
be vertically fixed on ground or a certain pedestal made of
wood or concrete before use to prevent the sand filter from
accidental falling. Fully assembled sand filter will exceed
18 kg. The mounting holes should be 8 mm in diameter and
spaced 86 mm apart. Use two bolts and nuts with a maximum
of 8 mm in diameter to fasten the sand filter to the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE: Use only special pool-grade filter sand, free of all limestone
or clay: #20 Silica sand 0.45-0.85 mm, approximately one 45 kg bag
should suffice. If you do not use the recommended size of filter sand,
filtering performance will be reduced and the sand filter may dam-
aged, thereby voiding the warranty.
IMPORTANT: We suggest using #20 silica sand with your pool
sand filter. It is specially graded to trap particles in the 20 - 100
micron range.
Some small debris can pass throw the sand and back into the
pool. This is normal, especially if the debris is fine or silt.
To limit this, it is better to follow the maintenance instructions,
and backwash and rinse when necessary.
We also suggest contacting your pool dealer for the chemical
product specifically made to clean the sand. The correct
maintenance of the sand will optimize the cleaning efficiency and
avoid accumulation of oils or scale.
When you are vacuuming the bottom of the pool that has a large
amount of debris, we suggest to backwash the sand when you
(You will need a screwdriver.)
8
86 mm
Ф8 mm