Vision Fitness 60 Bedienungsanleitung Seite 5

• Feed the heart rate wires of the HANDLEBAR (7) through the small hole located in
the front of the console mast. Pull these wires up through the hole at the top of the
3
console mast. Attach the handlebar to the console mast using 4 BOLTS (G). Tighten
with the 5MM L-SHAPE WRENCH.
PINK BAG
Description
G M8x20L Bolt
Qty
4
7
G
• Remove the four mounting bolts from the back of the CONSOLE (9) and four screws
2 4 holding the CONSOLE BACK COVER (8) with the screwdriver. (U60)
• Plug in the wire harness and the two heartrate wires to the back of the console.
• Attach the CONSOLE (9) to the console mast with the four bolts removed from
the console.
• Plug in the 9-volt battery. (U60)
• Re-attach the CONSOLE BACK COVER (8) with the four screws removed previously.
(U60)
• Attach the CONSOLE BACK COVER (8) packed within frame carton by 2 PRE-
INSTALLED SCREWS on CONSOLE (9). (U600E)
• Attach the ACCESSORY TRAY (10) and PLASTIC BASE (11) to the console mast with
the 2 BOLTS (H) by 6MM L-SHAPE WRENCH.
ATTENTION: Fix the water bottle until it firmly but DO NOT over tighten.
YELLOW BAG
Description
H M8x25L Bolt
U60
9
H
10
U600E
9
H
10
Qty
2
8
11
8
11
5