auna Microstar Sing Bedienungsanleitung Seite 44

EN
44
Common ways to configure your TV
1. You karaoke system is designed to connect to your TV. The karaoke
system is constantly sending the video and audio signals to the 'VIDEO
OUT' and 'AUDIO OUT' jacks whenever you play a CD+G disc. So,
load a CD+G into your karaoke system before you start making these
connections. You will see lyrics on the TV screen as soon as you have
completed the setup correctly.
2. The setup of your TV is the most difficult part of making the connection
for displaying your lyrics. In most homes, the TV has either cable
connected or an antenna in use. Once you connect your karaoke system
to the TV, you must 'tell' your TV to display the input from the karaoke
system instead of the usual input from the cable or antenna.
3. Check your TV user manual for the easiest way to setup your particular
entertainment system. If you do not have your manual, you can always
call your TV manufacturer for that information or try
for online assistance. We have listed below the most common ways of
setting up a TV:
• In the setup menu for configuring the TV there may be an 'Input
Selection' option where you may choose between 'Cable/Ant.', 'Video 1',
or 'Video 2' etc. as the input source.
• Try looking for a 'Video' channel between the highest channel and the
lowest channel on your TV (i.e. between 2 and 99 may be 'VIDEO' or
'INPUT').
• Look for buttons on the remote control for the TV you are connecting to
that say 'VIDEO', 'VIDEO 1', 'AUX', 'EXT', 'LINE 1. The 'LINE-IN' button will
display the Video input source.
Audio connection
Connect the unit to your TV or home stereo system using the White and Red
connections on the supplied patch cord. Plug the white end of the patch
cord into the white AUDIO OUT jack on the unit. Plug the red end of the
patch cord into the red AUDIO OUT jack on unit. Now connect the other end
of the cable's white (left channel) and red (right channel) plugs to your TV
or home stereo system's 'AUDIO IN' or 'AUX IN' jacks.
Connecting a microphone
1. Plug a microphone (one microphone is included) into the MIC 1 or MIC
2 JACK on the lower left side of your unit. The mic output will be mixed
with an audio source from CD/CD+G/USB flash drive.
2. Slide ON/OFF switch on microphone to "ON" before singing and always
slide to "OFF" after use.
Caution: Tapping or dropping the microphone while it is on can cause
permanent damage to it. Never grip and swing the microphone around by
the connecting cord.
their website