SCHUBERTH F 220 Gebrauchsanleitung Seite 27

PROTECTIVE EFFECT OF THE VISOR
The visor conforms to Optical Class 2 and is thus suitable for extended periods of
use. The degree of protection provided by the visor against radiant heat depends on
the temperature of the heat source. The higher this temperature is, the greater the
harmful heat to which the eyes are exposed. The visor should only be used in situa-
tions in which it is possible to restrict the exposure of the eye to less than
100 W/m .
2
CHANGING THE VISOR SHIELD
Removal: Release the two slotted screws on the visor's visor shield retainer. Press
the support together and remove the visor.
Installation: Gently press the visor together and put it in place at the two retainer
points located laterally inside the helmet. Ensure that the pin located centrally on the
support is sitting in the guide line on the inner surface of the helmet, then tighten the
two slotted screws (1.1Nm +/- 0.1Nm).
Do not remove the protective film on the visor shield until the visor has been
fitted onto the helmet.
28