SCHUBERTH F 220 Gebrauchsanleitung Seite 18

Notes on use of the helmet
The SCHUBERTH F 220 firefighter helmet is designed for use in firefighting in build-
ings, rescue and salvage activities, for work associated with road accidents and gen-
erally for activities within the scope of a fireman's duties. Use for any other purpose
is to be ruled out and will release SCHUBERTH from any and all liability. The visor is
specifically designed for use with the SCHUBERTH F 220 firefighter helmet and
must not be used for any other form of application.
Important! This helmet only gives full protection when sitting optimally on your
head, the headband is properly adjusted to your head circumference and the
chinstrap is closed. Detachable parts may not be worn/used separately. Only
wear the helmet when it is fully assembled.
Important! This helmet is designed to absorb the effect of only one impact. In
the same way as the crumple zone of a car's bodywork, the F 220 absorbs a
strong force acting on it through complete or partial destruction of the helmet
shell and lining structures. The helmet should be replaced after an impact or sig-
nificant blow, even if the damage is not immediately visible.
Liability for functioning and damage
Liability for the performance of the SCHUBERTH F 220 fire helmet shall in any event
transfer to the owner or operator if and when the SCHUBERTH F 220 fire helmet is
improperly serviced or repaired by persons not affiliated with SCHUBERTH GmbH or
trained by SCHUBERTH GmbH, or if the helmet is handled in a manner which does
not correspond to the intended use. SCHUBERTH GmbH shall not be liable for dam-
age occurring as a result of failure to comply with the above instructions.
19